研究论文 研究快讯 综述 简讯 会议介绍和国内外著名的从事能源化学研究机构的简介等
Preparation of manuscripts (Template)
The manuscripts should be printed on good quality A4 paper in a 12 pt Times New Roman font. All manuscripts should include: a title, list of authors, full addresses of authors, an abstract, keywords, all sections of the body of the manuscript, footnotes, and references.
The title should clearly and accurately indicate the contents of the article or communication and should be expressed in adequate scientific terms. No abbreviations should be used in the title.
The full addresses of authors should be placed below the title.
Footnotes should be included on the first page to give the phone number, fax number, and e-mail address of the author of correspondence, and if applicable, information regarding funding.
We request that authors should submit abstracts for both articles and communications. Abstracts should state briefly the reason for the work, the significant results, and conclusions.
Keywords should be given at the bottom of the abstract to serve as guidelines for indexing.
The body of the manuscript should be subdivided into the following sequence of the sections: Introduction, Experimental, Results and discussion, Conclusions, and References.
Tables and figures must be numbered consecutively with Arabic numerals and should be self-explanatory. Tables must have a brief descriptive title and include footnotes if necessary.“Figure” should be spelled out instead of being written“Fig.” Figures should have figure captions, either with the figures or collected on a separate sheet. The contents of figures, tables, and word descriptions should not be duplicated.Important instructions concerning Figures and Tables are listed as follows:
Each figure should be located at bottom of the paragraph where it is mentioned first in the text.
Size and font of all words including the X and Y axis, units and legends are 7.5 pt and Times New Roman, respectively. The first letter in the first word is capitalized.
Physical quantity is in italic, and the physical quantity and unit is separated by /not by · or blank, such as T/K,Ea/eV,Z/Ω, mL/min, mL/(h?gcat). When English full name of physical quantity is used, unit should be placed in the parenthesis and there is one blank space between them, such as Potential (V),Capacity (mAh/g),Current efficiency (%).
Digit and unit is separated by one blank space. Percentage of weight and volume should be wt% and vol%, not wt.% and vol.%.
Width of figures or images is 8 cm (single column) or 16 cm (double column).
For digital figures, they should be edited in the text. For SEM, TEM, HR-REM images or other photos, their resolution is more than 300dpi
When a figure title contains a few different figures, each figure should be numbered using (a), (b), (c), (d) …… which are inserted in the upper left corner of each figure with closed frame. When a figure contains different lines, these lined should be numbered using (1), (2), (3), (4) …… even though the lines are also differentiated by different colors.
Table must be three-lined format.
Photographs should be of sufficiently high quality with respect to detail and contrast. Indicate the magnification by a bar on the photograph.
References should be numbered consecutively in the order in which they are first mentioned in the text. Abbreviations of journal titles should follow the style used in Chemical Abstracts. Reference accuracy is critical and authors are responsible for the accuracy of the references. Only articles that have been published or are in press should be included in the references. Journal articles and books must be cited by the following formats:
Reference to a journal publication:
[1] J. van der Geer, J.A.J. Hanraads, R.A. Lupton, J. Sci. Commun. 163 (2000) 51–59.
Reference to a book:
[2] W. Strunk Jr., E.B. White, The Elements of Style, third ed., Macmillan, New York, 1979.
Reference to a chapter in an edited book:
[3] G.R. Mettam, L.B. Adams, in: B.S. Jones, R.Z. Smith (Eds.), Introduction to the Electronic Age, E- Publishing, Inc., New York, 1994, pp. 281–304.
All manuscripts should include a graphic abstract. Authors are required to provide a single separate A4 sheet containing a small diagram, or other informative illustration (scheme, formula, figure, etc.) that shows the most important aspect of the paper. The diagram or illustration should be a maximum size of 40 mm high×80 mm wide with color. Style and format of the graphical abstract may be found in the example.
编辑部审稿周期1-3个月,不代表你现在投稿,审稿周期一到就能发表,仅仅是在这个时间内审核你的文章,编辑老师每天会收到很多稿件,即使你的文章优秀,被审完后无任何问题,也需要排期发表,因为在你之前已经有很多稿件了,每一期杂志就那么点版面,投稿量远大于现有版面量,今年投稿的论文,正常是需要等到明年(甚至是下半年、后年)见刊,自行投稿会更慢,这是目前行业现状。
本站拥有大量优质期刊资源,可帮助您以最快速度见刊,尽全力满足您的用稿需求!版面紧张,如急需用稿,还请抓紧联系我们的在线老师,帮您寻找最符合您需求的杂志!随着今年版面费以及投稿费用的增长,本站也想尽全力为顾客省时省力省钱,现通过本站在线咨询添加在线老师微信下单的顾客,一律92折优惠!
温馨提示:杂志社审稿周期1-3个月,不代表你现在投稿,审稿周期一到就能发表,仅仅是在这个时间内审核你的文章,审稿人每天会收到很多稿件,即使你的文章优秀,被审完后无任何问题,也需要排期发表,因为在你之前已经有很多稿件了,每一期杂志就那么点版面,投稿量远大于现有版面量,今年投稿的论文,正常是需要等到明年(甚至是下半年、后年)见刊,自行投稿会更慢,这是目前行业现状。
123学术网是专门为科研工作者提供学术期刊查询、论文投稿及写作指导的服务平台,主要服务内容有中文论文服务、SCI协助发表服务、实验技术服务、课题基金服务等。品牌创立至今,123学术网始终致力于解决用户在选刊、写作、投稿中遇到的难题。经过11年风雨,123学术网已与1316家杂志达成合作,坚持用诚信铸造口碑,用真心服务客户,逐渐成为学术论文行业的专家。